We're so confident of our products that we provide no hassle product exchange.
HP Implementing HP Network Infrastructure Solutions Sample Questions:
1. A company's HP Provision ASIC switches are configured to use PIM-SM mode to provide multicast services. When an HP Provision ASIC switch receives a multicast stream, it determines that the best path to the multicast source is not through the Rendezvous Point (RP). Which action might this switch take?
A) The switch may use the backup RP if this RP is in the path between the multicast source and its receivers.
B) The switch may send a graft message on the interface through which it reaches the multicast source.
C) The switch may establish itself as the new RP for the shortest path tree.
D) The switch may decide to join the shortest path tree.
2. Which statement accurately describes how network administrators can apply routed access control lists (RACLs) or VU\N access control lists (VACLs) on an HP 8200 zl switch?
A) A RACL controls all inbound or outbound routed traffic on a particular port.
B) A VACL applies to any traffic switched within a VLAN.
C) A VACL applies to traffic routed within a particular VLAN.
D) A RACL is applied at the global configuration level to filter all traffic routed on the switch.
3. Which security protocol introduces vulnerabilities because the password is sent in plaintext and can be intercepted and easily read?
A) EAP
B) WEP
C) CHAP
D) PAP
4. View the exhibit.
The HP 5406 zl switch configured with the VLANs shown in the exhibit receives a packet on a port that is an untagged member of VLAN 101. The packet is tagged with VLAN 20. What will the switch do?
A) The switch will drop the packet because the port must be a tagged member of VLAN 20.
B) The switch will drop the packet because the port must be a member of a C-VLAN.
C) The switch will remove the 802.1Q field and forward the packet.
D) The switch will insert another 802.1Q field and forward the packet.
5. View the exhibit.
All switches in this figure are HP Provision ASIC switches. They are enabled to establish adjacency with neighbors on all of their VLAN interfaces. Besides these configurations, they are operating at the default OSPF settings. How can a network administrator ensure that routing switch B uses the 10G link to reach 10.1.10.0/24 if its direct link to routing switch A fails?
A) Set the VLAN 103 bandwidth to 1000.
B) Set the VLAN 100 bandwidth to 10000.
C) Set its reference bandwidth to 10000.
D) Set the VLAN 103 OSPF cost to 10.
E) Set the VLAN 100 OSPF cost to 10.
Solutions:
| Question # 1 Answer: D | Question # 2 Answer: B | Question # 3 Answer: D | Question # 4 Answer: D | Question # 5 Answer: C |
By Lynn
