EMC DES-1121 Real Exam Questions Guaranteed Updated Dump from TopExamCollection
Verified Pass DES-1121 Exam in First Attempt Guaranteed
Dell EMC PowerMax and VMAX Family Solutions Specialist Exam Certification Details:
| Number of Questions | 60 |
| Books / Training | PowerMax and VMAX Family Configuration and Business Continuity Administration - Classroom (ES112STG00370) PowerMax and VMAX Family Configuration and Business Continuity Administration - Virtual Classroom (ES122STG00644) |
| Schedule Exam | Pearson VUE |
| Duration | 90 mins |
| Passing Score | 63% |
NEW QUESTION 28
What is the maximum number of bricks that can be configured on a PowerMac 8000 system bay?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 29
Two RDF groups from two PowerMax arrays have been added to a Consistency Group SRDF/A Multi-Session Consistency has been enabled for the Consistency Group. The RDF daemon has been started on a single host that has access to both the PowerMax arrays What will happen if the host becomes unavailable?
- A. Cycle switching will stop
- B. RDF links will be suspended immediately
- C. SRDF mode will change to Adaptive Copy Disk
- D. SRDF pair state will become Partitioned
Answer: D
NEW QUESTION 30
What is the minimum required memory and minimum required disk space to manage a maximum volume count of 64000 and 10 arrays when installing Unisphere for PowerMax?
- A. 24 GB of available memory and 180 GB of available disk
- B. 12 GB of available memory and 120 GB of available disk
- C. 16 GB of available memory and 160 GB of available disk
- D. 8 GB of available memory and 100 GB of available disk
Answer: B
NEW QUESTION 31
Which port flag is required for auto-provisioning?
- A. SC3
- B. V
- C. SPC2
- D. ACLX
Answer: D
NEW QUESTION 32
A PowerMax administrator modified a Storage Group to add more volumes. The administrator then decides to use the Suitability Check to ensure compliance is met. The Suitability check runs but does not provide any information.
What is the likely cause for this issue?
- A. Array has not been registered for performance data collection
- B. Steps were skipped in the Modify Storage Group setup before running the Suitability Check
- C. Volumes were added to the Storage Group before using the Suitability report
- D. Suitability Check was run before the Storage Group was configured
Answer: B
NEW QUESTION 33
A VMAX3 array has been configured with two Storage Resource Pools (SRP) Source volumes are assigned to SRP_1 and target volumes are assigned to SRP_2. A TimeFinder SnapVX snapshot of the source volumes is linked to the target volumes in the default mode What will happen when there are new host writes to the source volumes?
- A. Snapshot deltas will be stored in SRP_1
- B. Snapshot deltas will be stored in SRP__2
- C. Snapshot deltas will be stored in the Reserved Capacity of SRP_2
- D. Snapshot deltas will be stored in the Reserved Capacity of SRP_1
Answer: A
NEW QUESTION 34
When using TimeFinder SnapVX, what is the maximum number of linked targets allowed per source?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 35
Which VMAX All Flash software package includes Non-Disruptive Migration?
- A. Pro
- B. Essentials
- C. FX
- D. AppSync Starter
Answer: D
NEW QUESTION 36
An administrator is managing two PowerMax arrays that are located in two different data centers. The data centers are 550 km apart and are connected by a high bandwidth network link. The administrator wants to replicate data between the two arrays and achieve the lowest RPO When using SRDF. which mode meets this requirement?
- A. Adaptive Copy
- B. Asynchronous
- C. Metro
- D. Synchronous
Answer: C
NEW QUESTION 37
What is the performance metric for the read-to-write ratio of workloads on a specific logical block address?
- A. Prefetch
- B. Workload type
- C. Workload clustering
- D. Data spanning
Answer: B
NEW QUESTION 38
A systems administrator no longer needs the remote replica of a local device. Which step can be performed first in order to perform the deletepair function?
- A. Suspend the SRDF link
- B. Change the type of the group to "regular
- C. Split the SRDF link
- D. Change the pair state to "NR"
Answer: A
NEW QUESTION 39
Refer to the Exhibit.
Which service levels are available for CKD devices'?
- A. All service levels
- B. Diamond and Platinum only
- C. Diamond, Bronze, and Optimized only
- D. Service levels are not used
Answer: D
NEW QUESTION 40
What is the status of the Host I/O paths to the target array after a Non-Disruptive Migration Cutover?
- A. Write Disabled
- B. Read/Write Enabled
- C. Dead
- D. Inactive
Answer: B
NEW QUESTION 41
A systems administrator has decommissioned a host with two devices allocated to it. What must the administrator do prior to deleting the devices?
- A. Remove the Storage Group
- B. Unmap from the front-end ports
- C. Remove the device attribute
- D. Delete the Initiators
Answer: A
NEW QUESTION 42
What takes place during an SRDF Establish operation?
- A. Enables access to both the R1 and R2 devices on the hosts
- B. Changes made to the R1 are propagated to the R2. Changes made to the R2 are discarded
- C. Changes made to the R2 are propagated to the R1 Changes made to the R1 are discarded.
- D. Resumes normal SRDF mirroring and host access
Answer: A
NEW QUESTION 43
Exhibit.
Which activity needs to be performed prior to the operations shown in the exhibit?
- A. Target volumes should be unmounted
- B. Target volumes should be unmapped
- C. TTL setting should be changed
- D. Snapshot should be terminated
Answer: C
NEW QUESTION 44
On a PowerMax or VMAX Family array, what is the default Dynamic I/O distribution mode setting when a Storage Group is associated with Host I/O Limits?
- A. On Failure
- B. Balanced
- C. Always
- D. Never
Answer: D
NEW QUESTION 45
What does a service level define*?
- A. Expected average response time target for a disk group
- B. Expected average throughput for a disk group
- C. Expected average response time target for a Storage Group
- D. Expected average throughput for a Storage Group
Answer: C
NEW QUESTION 46
On a PowerMax what is the correct sequence of steps to deduplicate data?
Answer:
Explanation:
NEW QUESTION 47
Where are the Host l/Os directed to when the Storage Group is in a Non-Disruptive Migration CutoverReady state?
- A. Held in host cache
- B. Source and target arrays
- C. Source array only
- D. Target array only
Answer: D
NEW QUESTION 48
Where is the automatic backup feature for the Solutions Enabler Group Name Services database set?
- A. SYMAPI variable
- B. Daemon options file
- C. SYMAPI options file
- D. SYMCLI environment variable
Answer: A
NEW QUESTION 49
......
EMC DES-1121 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
Download Real EMC DES-1121 Exam Dumps Test Engine Exam Questions: https://examcompass.topexamcollection.com/DES-1121-vce-collection.html
